Sym Red common MOT failures and failure rate

Brake failures cover worn pads and discs, an imbalance between wheels, corroded or scored discs, or a binding caliper. Braking efficiency is measured on a rolling road, so a spongy or pulling brake shows up as a low reading.

Lighting is the single most common MOT failure and the cheapest to put right. A blown headlight, brake-light or number-plate bulb, a cracked lens, or a headlamp beam that points too high or low will all fail. Most are a two-minute bulb swap.

Exhaust failures cover leaks, insecure mountings and emissions over the limit. A blowing exhaust, a failed lambda reading or a diesel that smokes beyond the limit will fail.

This covers a range of smaller items, from a non-working horn to a warning light left on.

Tyres fail for tread below the 1.6mm legal limit across the central three-quarters, uneven or exposed-cord wear, or sidewall damage. The tester inspects all four; a single illegal tyre is a fail.

Suspension failures usually mean a worn or snapped coil spring, a leaking shock absorber, or play in a lower arm ball joint or bush. The tester checks for corrosion, fractures and excessive movement. A broken front spring is one of the most common failures on higher-mileage cars and is a straightforward replacement.