Siamoto Kd MOT failure rate

Lighting is the single most common MOT failure and the cheapest to put right. A blown headlight, brake-light or number-plate bulb, a cracked lens, or a headlamp beam that points too high or low will all fail. Most are a two-minute bulb swap.

Brake failures cover worn pads and discs, an imbalance between wheels, corroded or scored discs, or a binding caliper. Braking efficiency is measured on a rolling road, so a spongy or pulling brake shows up as a low reading.

This covers a range of smaller items, from a non-working horn to a warning light left on.

Suspension failures usually mean a worn or snapped coil spring, a leaking shock absorber, or play in a lower arm ball joint or bush. The tester checks for corrosion, fractures and excessive movement. A broken front spring is one of the most common failures on higher-mileage cars and is a straightforward replacement.

Structural failures are corrosion in load-bearing areas, sharp edges, or insecure panels. These are inspection-and-welding jobs rather than a simple bolt-on part, so weigh them against the value of the car.

Steering faults are typically worn track-rod ends or ball joints, play in the rack, or a split gaiter letting grease out and dirt in. Excessive free play at the wheel fails.