Daimler X3000 MOT failure rate

Lighting is the single most common MOT failure and the cheapest to put right. A blown headlight, brake-light or number-plate bulb, a cracked lens, or a headlamp beam that points too high or low will all fail. Most are a two-minute bulb swap.

Suspension failures usually mean a worn or snapped coil spring, a leaking shock absorber, or play in a lower arm ball joint or bush. The tester checks for corrosion, fractures and excessive movement. A broken front spring is one of the most common failures on higher-mileage cars and is a straightforward replacement.

Tyres fail for tread below the 1.6mm legal limit across the central three-quarters, uneven or exposed-cord wear, or sidewall damage. The tester inspects all four; a single illegal tyre is a fail.

Visibility failures include torn or smearing wiper blades, a washer jet that does not reach the screen, and chips or cracks in the driver's swept area. Blades and washer fluid are quick, cheap fixes.

Exhaust failures cover leaks, insecure mountings and emissions over the limit. A blowing exhaust, a failed lambda reading or a diesel that smokes beyond the limit will fail.

Brake failures cover worn pads and discs, an imbalance between wheels, corroded or scored discs, or a binding caliper. Braking efficiency is measured on a rolling road, so a spongy or pulling brake shows up as a low reading.